ChennaiChennai

mobile number +91 9500611963

email info@chennaiservicecenters.in

  • facebook
  • instagram
  • twitter
  • youtube
  • pinterest

LE, E1, E9, LC, C1 error in Samsung washing machine

If the Samsung electronics washing machine shows the error LE, E1, E9, LC, C1 (depending on the model), this is accompanied by a washing stop a couple of minutes after starting or after draining and pouring water in a circle. At the same time, water spreads on the floor. A fault code can also knock out just like that when no leaks are visible.

Error LE, E1, E9, LC, C1 means that there is a leak in the tank, or water pours out on its own without the necessary command. Before the arrival of the mechanic, it is worth trying to solve the problem yourself. Not always such codes report breakdowns.

Can I reset myself?

It may not be the tank itself that is leaking, but the place where the drain hose connects to the sewer. During self-diagnosis, you need to make sure that the machine is installed correctly, since water is arbitrarily drawn in and drained if installation requirements are violated. It happens that a drain filter that is loosely installed after cleaning passes water, you just need to twist it tighter.

If you see that water is flowing from the powder tray, the dispenser itself is most likely clogged. Poor quality powder may be to blame for everything, due to which a lot of foam appears in the tank. It is also necessary to carefully check all cables, connections, and contacts.

Error LE, E1, E9, LC, C1 also happens due to a temporary software failure of the control module. This issue is resolved by rebooting. The machine is disconnected from the network and stays like this for up to 15 minutes, then it turns on again.

What are the breakdowns?

If after restarting the error LE, E1, E9, LC, C1 does not disappear, this indicates such malfunctions:

Breaking Causes How to eliminate
Leak underneath the pan. Damage to the sealing rubber cuff of the hatch. (or) Drainpipe broken. For minor damage, you can glue the cuff. If it doesn't work, it needs to be replaced. (or) Sealing or installing a new pipe.
The error appears immediately after switching on. The pressure switch is faulty. Repair the tube or completely installing a new pressure switch.
The code knocks out at different stages of the program. The display unit is broken. Repair, in rare cases - replacement of the display unit.
If there is an aquastop function, after starting the program, a code is displayed indicating a leak. Failure of the leakage sensor. Installing a new leak sensor.
Leak at the back of the machine. Drain hose broken. Drain hose replacement.
The error appears and disappears periodically. Damage to contacts / wiring. Restoration of contacts / wiring.

If you have any questions or want to call the mechanic, call us (order a call back)