Chennai
+91 9500611963
info@chennaiservicecenters.in
Chennai
+91 9500611963
info@chennaiservicecenters.in
If the F8 error appears on the display of the washing machine, it means that the machine has stopped spinning or is spinning the laundry at low speeds. Further use of the device cannot be, so as not to aggravate the situation. Starting the machine with a broken spin function can lead to more serious damage.
In this case, you need to seek help from service center mechanic. They will diagnose, identify the cause, and eliminate it so that you can use the device again.
Error F8 appears when the drum rotation speed during the spin cycle is lower than usual. The peculiarity of this error is that it is not displayed in the wash mode. To identify deviations in the speed of rotation of the drum, you need to run a verification test. If a discrepancy with the norm is detected by more than 100 rpm, after the test is completed, the code F8 will be displayed on the display.
Most often, the machine starts to rotate the drum more slowly due to problems with the motor. Jamming of the drum itself may also occur because a foreign body has got into it. In some cases, the problem lies in a faulty electronic control module.
| Problem | Source of occurrence | Elimination Methods |
| The drive belt is in the wrong position. | The drive belt can stretch, break, or become dislodged over time, causing the drum to spin more slowly. | Check the position of the belt, correct it, or replace it with a new one if necessary. |
| Defective drive motor. | In some cases, the motor may burn out. | Inspect the electric motor, if it cannot be repaired, replace the part. |
| Inverter failed (for models PG4-PG5) | Due to a long service life or other adverse factors, the inverter may burn out. | Carry out diagnostics, if necessary, replace the part. |
| A controller error has occurred. | The electronic module may fail or burn out due to a failure in the electrical system. | This is a complex repair since special knowledge and experience are needed to replace the module. Contact a qualified service center to replace the controller. |
If you have any questions or want to call the mechanic, call us (order a call back).
9500611963 info@chennaiservicecenters.in