F5 error in Gorenje washing machine

When the Gorenje washing machine breaks down, it emits a special sound signal, an error code is displayed on the display, and the signal light starts flashing. Sometimes the program can be completed to the end, but in most cases, further operation is impossible. To resume washing, contact a qualified service center. They will quickly come to the call, diagnose, and replace all damaged parts.

F5 error in Gorenje PG1-PG3 washing machines.

If your washing machine has stopped rotating the drum, and error F5 is displayed on the screen, then you need to look for a problem. This can happen because the electric motor is very hot, and the triac burns out. Follow these steps to restore your work.

• Restart the washing machine to eliminate the possibility of a temporary failure in the electronic system. To do this, turn it off and on again after 15 minutes.
• Inspect the motor, in case of damage, change the winding or the electric motor.

If the above actions did not bring results, you need to check the triac and the electronic board. In case of malfunction, replace parts.

F5 error in Gorenje PG4-PG5 washing machines

When the device stops in the middle of the cycle and displays the code F5 on the electronic display, it means that the connection between the electronic board and the inverter is broken. This happens when the links of the electrical circuit burn out. Signals between the controller and the inverter are no longer transmitted. You can try to fix the error yourself.

• Ring the electrical circuit, if you need to replace damaged areas, do it.
• Check the operation of the inverter and controller, they may need to be replaced or repaired.

If you cannot solve the problem yourself, contact the service center for help.

F5 error in Gorenje WA-101/121/132/162/162P washing machines

Your machine has stopped draining water or does not drain it completely, and the F5 code is displayed on the screen - it means that a drain error has occurred. This can happen due to several reasons.

• The pump has broken, or its electrical circuit has broken.
• The drain system (hose, filter, or nozzles) is clogged with debris or foreign objects.
• The pressure switch is faulty.
• The controller has failed.

To restore your work, follow these steps.

Check the drain system for debris, the drain hose is good, and the filter is not clogged. If necessary, purge the system.

• If the pump or water level sensor is damaged, replace it with new parts.
• In the event that the pressure switch breaks down, it is better to turn to specialists, since special knowledge of electronics is needed to replace it.

If you have any questions or want to call the mechanic, call us (order a call back).