If the Samsung electronics washing machine shows an error 6E, EB, BE, BE1, BE2, BE3 (depending on the model), this is accompanied by an unplanned spin on at maximum speed. This happens immediately after pressing the start button, or after water has accumulated in the tank. It may also be that the program does not start at all and immediately knocks out a fault code.
Errors 6E, EB, BE, BE1, BE2, BE3 indicate difficulties with starting the unit. Depending on the display, it is shown in two or three characters. Malfunctions are most often associated with a thyristor switch, stuck buttons, or a broken control board. In most cases, such codes report problems, although it is worth trying to solve the problem yourself before the mechanic arrives.
The problem may be sticky or loose buttons. It is eliminated by repeatedly pressing or holding the key for some time. Sometimes loosening the front panel fixing screws helps. It happens that the reason lies in the outlet - it is damaged, or the voltage is too weak. If sparks appear, it must be replaced.
Error 6E, EB, BE, BE1, BE2, BE3 also occurs due to a temporary software failure of the control module. This issue is resolved by rebooting. The machine is disconnected from the network and stays like this for up to 15 minutes, then it turns on again.
If error 6E, EB, BE, BE1, BE2, BE3 does not disappear even after a reboot, this indicates such malfunctions:
Breaking | Causes | How to eliminate |
After starting, the drum immediately rotates at maximum speed, then freezes. | The thymistor or TRIAC broke. The reason is a short circuit. | Installing a new thyristor. Sometimes it is also necessary to install new diodes and a switching relay. |
The drum slowly spins up to maximum speed at the beginning, in the middle or at the end. | Hall sensor broken. | Restoration of contacts or replacement of the Hall sensor. |
When pressing the buttons, the unit does not respond. Some keys always remain pressed. | Buttons are faulty. | Installation of new keys instead of broken ones. After that, you will need to adjust the front panel. |
The drum immediately spins at maximum speed, or the washing machine does not start at all. | Failure of the electronic module. | Resoldering and restoration of burned-out module elements. If the problem is in the processor, replace the board. |
The program does not start, the breakdown code appears immediately after switching on. | Damaged or incorrectly connected motor relay. | If the tracks are damaged, they are soldered. In the event of a breakdown of the entire relay, a new one must be installed. |
The error appears and disappears periodically. | Damaged wiring / contacts. | Restoration or replacement of wiring / contacts. |
If you have any questions or want to call the mechanic, call us (order a call back)